E-4
System configuration
This system includes an amplifier unit, five satellite
speakers and a subwoofer.
The three satellite speakers with a 3 m cord are used for
front speakers and a center speaker.
The two satellite speakers with a 7 m cord are used for
surround speakers.
The roll of respective speakers
The front speakers are used for outputting main channel
sound. The surround speakers are used for effect sounds,
and the center speaker is for center channel sound (dialog
etc.).
The subwoofer is used for outputting sounds of low
frequencies from the front, center and surround channels.
The subwoofer also outputs sounds of the subwoofer
channel when a source is played with DTS or Dolby Digital
decoded.
Setting up the system
Recommended speaker placement
Before making connections, place all speakers in their
respective positions. The positioning of the speakers is
important because it controls the whole sound quality of this
system.
Place the speakers depending on your listening position by
following the instructions below.
* The satellite speakers can be mounted on a wall.
Front speakers: On both sides of and at approximately
the same height as the TV (or computer
monitor).
Surround speakers:
Behind your listening position or on
both sides of the listening room.
Center speaker: Precisely between the front speakers.
* Though the center speaker can be
mounted on the monitor as shown on
the next page, it is not so
recommended for safety.
Subwoofer: On the foor. The position of the
subwoofer is not so critical because low
bass tones are not highly directional.
It is recommended to place the
subwoofer obliquely facing the wall.
Now making an
illustration
SR601ENG(9/29)e 00.9.29, 2:34 PM4
