6 © Titan Tool Inc. All rights reserved.
English
Trigger Selector (Two-Gun units)
1. Set the trigger selector for proper spray gun operation.
The gun lever on the right handlebar triggers the gun or
guns. The selector on the trigger must be set for the rst
gun, both guns, or the second gun .
IMPORTANT: Always turn the trigger lock on the spray gun
to the locked position before making any adjustments to the
trigger selector. Also, release the trigger cable from its block
by lifting the cable up and out of the block. There will be a
brief triggering of the gun while releasing the trigger cable.
a. First Gun — The rst
gun position is with
the selector in the left
position. Push the lever
toward the inside of
the frame until the pin
engages the left plate.
b. Both Guns — The dual
gun position is with the
selector in the center
position. Push the
lever toward the center
position until the pin
engages both plates.
The pin must engage
both plates.
c. Second Gun — The
second gun position is
with the selector in the
right position. Push
the lever away from the
inside of the frame until
the pin engages the right
plate.
Preparing a New Sprayer
If this unit is new, it is shipped with test uid in the uid section
to prevent corrosion during shipment and storage. This uid
must be thoroughly cleaned out of the system with mineral spirits
before you begin spraying.
Trigger lock in
IMPORTANT: Always keep the trigger
lock on the spray gun in the locked
position while preparing the system.
1. Place the siphon tube into a
container of mineral spirits that has a
ash point of 60ºC (140ºF) or above.
2. Place the return hose into a metal
waste container.
PRIME
3. Turn the pressure control knob
fully counterclockwise to its lowest
pressure setting.
4. Move the PRIME/SPRAY valve to the
PRIME position.
5. Move the engine ON/OFF switch to
the ON position.
Fuel Valve
Lever
Choke Lever
Engine
ON/OFF
Switch
Throttle
Lever
Starter Rope
6. Start the engine:
a. Open the fuel valve
lever.
b. Move the throttle
lever to its middle
point.
c. Close the engine
choke lever.
d. Holding the frame
with one hand, pull
the starter rope
rapidly and rmly. Continue to hold the rope as you let
it return. Pull and return the rope until the engine starts.
Sprayer
ON/OFF
Switch
Pressure
Control
Knob
7. Turn on the sprayer by
moving the pump ON/OFF
switch to the ON position.
8. Allow the sprayer to run for
15–30 seconds to ush the
test uid out through the
return hose and into the
waste container.
9. Turn off the sprayer by
moving the pump ON/OFF
switch to the OFF position.
