Setting Up Your 2000i 11
The data connection for the internal computer is an RS-232 serial cable. If your computer has USB
ports, use the SMART USB adapter in the accessory box. Connect the DB9 end of this adapter to
the Computer 1 Serial cable and the USB end to your computer.
1. Slide the computer into place on the bottom storage shelf, above the computer straps, and
then secure the straps around the computer.
2. Locate the bundle of labeled cables (to the right of the projector) hanging down towards the
storage tray.
3. Connect the Computer 1 Video Out cable to the computer’s Monitor Video connector.
4. Connect the Computer 1 Audio cable to the computer’s Audio Line OUT connector.
5. Connect the Computer 1 Serial cable to an available serial port on the computer.
NOTE: If your computer has no available serial port, connect the SMART USB adapter
between the Computer 1 Serial cable and the computer’s USB port.
6. Connect the Mouse and Keyboard cables (not supplied) to the PS/2 mouse port and the PS/2
keyboard port on the computer.
1. Connect the Computer AC power cable to an available power outlet or power bar (not
supplied).
2. Connect the 2000i AC power cord to the country-specific AC cord in the accessory box. Then
connect this AC cord to an available power outlet or power bar (not supplied).
To connect a computer
To connect the power cables
Computer 1 Audio
Computer 1 Video Out (male)
2000i AC (male)
(connect to female country-specific AC Cable)
Computer 1 Serial (Female)
