A SERVICE OF

logo

Open as PDF
next previous
Page 5-9
Section 5. Mechanical Adjustments
SATO CL408e/CL412e Service Manual
PN 9001078
Rev. B
5.7 Print Head Alignment Adjustment
STEP PROCEDURE
1. Load the ribbon and label stock into the printer.
2. Loosen and adjust screw along slot to move indexing pointer for maximum
print quality. Fig. 5-8
To further optimize print quality, especially when using thick label stock, additional
adjustments are possible. Perform the following steps using head pattern as a guide.
MAJOR ADJUSTMENT
Required Equipment: #2 Pozidrv Screwdriver
Fig. 5-8
INDEXING POINTER
SHIFTS HEAD
BACKWARD/FORWARD