SATO CL412E Manual

A SERVICE OF

next previous

Page 9-13

Section 9. Optional Accessories

SATO CL408e/CL412e Service Manual

PN 9001078

Rev. B

Fig. 9-23

Fig. 9-24

ADJUSTING SLOTS (BOTH ENDS

OF RIBBON TENSION PLATE)

INSTALL RIBBON TENSION

PLATE AND PEEL BAR

USING (2) SUPPLIED LONG

SCREWS

STEP PROCEDURE

14. Load the labels and route the label backing down the front of the

print mechanism and around the Backing Drive Roller. Verify that

label backing material feeds through the dispenser assembly and

onto the Backing Take Up Spindle Assembly. Secure the label stock

to the take up spindle by inserting the label end between the core

and label retainers. Figs. 9-25 & 9-26

15. Manually turn the Backing Take Up Spindle counter clockwise to

take up all the slack in the backing. Swing the Label Dispenser

front mechanism into position until the latch engages. Take care

that the cable is properly routed to avoid crimping or damage.

Figs. 9-25, 9-27 & 9-28

Label Dispenser Installation