A SERVICE OF

logo

Page 6-28
Section 6. Replacement Procedures
SATO CL408e/CL412e Service Manual
PN 9001078
Rev. B
6.14 Replacing the Display Panel PCB
The Display Panel PCB is mounted inside the printer.
STEP PROCEDURE
1. Switch the printer OFF and disconnect the power cable.
2. Raise the access door and remove (2) screws holding the side cover to the
inside frame. Figs. 6-1
3. Remove (2) screws holding the side cover to the outside frame. Remove the
cover to expose the electronics.
4. Note cable connection locations, then detach the connectors from the display
panel PCB. Fig. 6-35
5. Remove (3) screws and detach the display panel.
6. Replace the display panel and reattach connectors.
7. Reconnect the power cable.
Fig. 6-35
REMOVE (3)
SCREWS
DETACH
CONNECTORS