A SERVICE OF

logo

Page 6-23
Section 6. Replacement Procedures
SATO CL408e/CL412e Service Manual
PN 9001078
Rev. B
6.10 Replacing the Ribbon Motion Sensor
The Ribbon Motion Sensor is easily replaced for service.
STEP PROCEDURE
1. Switch the printer OFF and disconnect the power cable.
2. Raise the access door and remove (2) screws holding the side cover to the
inside frame. Figs. 6-1
3. Remove (2) screws holding the side cover to the outside frame. Remove the
cover to expose the electronics.
4. Remove (1) screw which attaches the sensor to the frame. Figs. 6-29
5. Detach the SEN4 connector from the display panel PCB.
6. Remove the sensor unit from the printer.
7. Replace the sensor.
8. Reconnect the power cable.
REMOVE
SCREW
LEFT SIDE OF PRINTER RIGHT SIDE OF PRINTER
SENSOR
SENSOR
DISPLAY
PANEL PCB
DETACH
CONNECTOR
Figs. 6-29