Page 9-24
Section 9. Optional Accessories
SATO CL408e/CL412e Service Manual
PN 9001078
Rev. B
Flash Memory Expansion Installation
STEP PROCEDURE
4. Carefully press outward on the tabs on both ends of the Main PCB Board
Memory Frame to release the Standard Memory PCB. The Standard
Memory PCB should lift by itself when released. Remove the Memory
PCB from the frame. Note the indexing notches. Figs. 9-39
5. Remove the Flash Memory Module from the anti-static bag handling the
module by the edges. Note the indexing notches. Insert the module into
the Main PCB Memory Frame at approximately 45
0
away from the Main
PCB Board. Gently push down to snap into position. Figs. 9-40
6. Replace the cover reversing removal steps.
7. Complete the Factory Reset Procedure.
NOTE: Many of the components on this board are susceptible to damage by static
electricity. To avoid damage, do not unpack new circuit boards from anti-static bags
until instructed to do so and use a wrist grounding strap.
STANDARD MEMORY PCB IN THE
MAIN PCB MEMORY FRAME
* CAREFULLY PRESS OUTWARD
ON TABS ON BOTH ENDS OF THE
FRAME TO RELEASE THE MEMORY
PCB.
Figs. 9-39
INDEXING NOTCHES
*
*
PRESS OUTWARD
PRESS OUTWARD
