A SERVICE OF

logo

Open as PDF
next previous
Page 4-16
Section 4. Electric Checks and Adjustments
SATO CL608e/CL612e Service Manual
PN 9001079
Rev. B
4.12 Print Darkness Adjustment
STEP PROCEDURE
1. Turn VR1 potentiometer (located underneath a flip-down cover ot the
front panel) to the center postion.
2. Turn ON the power. Press the LINE key to go off-line. Then press
LINE and FEED keys simultaneously and the following message will
display.
3. Press LINE key and place the cursor under the print darkness desired,
then press the FEED key to enter.
4. Turn OFF the power.
5. Check the print darkness and adjust to suit with VR1.
print darkness
1(L) 2(M) 3(D)
POTENTIOMETERS ARE LOCATED
UNDERNEATH A FLIP - DOWN COVER
ON THE FRONT PANEL
VR1