SATO CL608e/CL612e Manual

A SERVICE OF

next previous

Page 5-8

Section 5. Mechanical Adjustments

SATO CL608e/CL612e Service Manual

PN 9001079

Rev. B

Required Equipment:  #2 Pozidrv Screwdriver

 10mm wrench

STEP PROCEDURE

1. Connect the power cable to the printer and AC outlet. Turn the printer

ON.

2. Raise the access door and load the ribbon and label stock. Fig. 5-1

3. Loosen the locking screws. Fig. 5-9

4. Turn eccentric with wrench.

5. When the carbon ribbon moves evenly without wrinkling, tighten the

locking screws.

LOOSEN

LOCKING

SCREWS

TURN ECCENTRIC

Fig. 5-9

NOTE: Only do this adjustment after adjusting ribbon wind and

unwind tension in Section 5.2.1 and 5.2.2

5.5 Ribbon Roller Adjustment