Page 2-16
Section 2. Configuration
SATO CL608e/CL612e Service Manual
PN 9001079
Rev. B
character pitch
prop fixed
STEP PROCEDURE
1. Use the LINE key to step the underlined cursor to the desired setting.
2. Once the desired setting is underlined, press the FEED key to accept
the setting and return to the Advance Mode screen.
Note: This command can be overriden by the <ESC>PR or <ESC>PS
Character Pitch Commands.
To exit the Advanced mode, power off the printer then back on.
This setting allows you to set the default character pitch to either fixed character spacing
or proportional character spacing.
Character Pitch
LCD Panel — Advanced Mode
ignore cr/lf
YES NO
STEP PROCEDURE
1. Use the LINE key to step the underlined cursor to either YES or NO.
2. Once the desired setting is underlined, press the FEED key to accept
the setting and advance to the Character Pitch display.
This setting tells the printer to strip out all carriage return/line feed pairs (CRLF) from the
data stream, including graphics and 2D bar codes. It is used primarily to maintain
compatibility with earlier models of SATO printers.
Ignore CR/LF
Advanced Mode
Exit Advanced Mode
