Page 6 of 28 Rev: 1/21/2014 8:35 AM
Energy Button Operation
The Energy button is designed to be a quick, efficient energy-saving option. When you press the Energy
(leaf) button, INSTEON Thermostat will adjust the Heat and Cool setpoints by a specified value. The
default value is 4° from the current setting. The default value can be changed via software such as
HouseLinc.
• When you exit Energy mode, it will revert back the 4° that was changed upon entry.
• The unit remains in Energy mode until the Energy button is pressed again.
• Up/Down arrows adjust the temperature setpoint based on the mode you are in.
• Energy button does nothing because the
system is off (at maximum energy savings
already).
• When “Energy” appears on the screen for
Auto, Cool and Heat Modes, the 4° setback
• Heat setback as specified.
• Default setback is 4° less.
• Notice that “Heating” is active on the left,
but not on the right since the setpoint is
lower that the actual temperature; the
• Cool setback as specified.
• Default setback is 4° more.
• Both Heat and Cool setpoints changed as
specified.
• Default setback is 4° more for Cooling and
4° less for Heating.
• Notice that “Heating” is active on the left,
but not on the right since the setpoint is
lower that the actual temperature; the
element reads “Heat.”
