Page 23 of 28 Rev: 1/21/2014 8:35 AM
• Temperature offset
• Humidity offset
Factory Reset
1) Press and hold INSTEON Thermostat’s Set button until it beeps.
INSTEON Thermostat will beep.
INSTEON Thermostat Set LED will blink green.
2) Press and hold INSTEON Thermostat’s Set button again until it beeps.
INSTEON Thermostat will beep.
INSTEON Thermostat Set LED will blink red.
3) Double-tap Set button.
4) Press and hold Set button again for about 10 seconds.
INSTEON Thermostat will emit a long beep and its display will blink all segments.
5) When blinking/buzzing stops, release Set button and wait 10 seconds.
INSTEON Thermostat will perform a series of self tests, then return to normal operations.
INSTEON Thermostat display will return to normal.
Specifications
Manufacturer product number
2732-422 EU
2732-522 AUS/NZ
UPC
813922-012859 EU
813922-012866 AUS/NZ
INSTEON powerline mesh repeater
LED
Red when Heating is active, green when Cooling is active
Off when neither mode is active
Blinks red or green during setup
LED can be enabled or disabled locally or via software
Commands supported as controller On Off
Commands supported as responder
