Page 5 of 28 Rev: 1/21/2014 8:35 AM
INSTEON Thermostat Operation and Programming
Mode Button Operation
• No setpoints are shown.
• Up/Down arrows do not do anything.
• Only Heat setpoint is shown.
• Up/Down arrows change Heat setpoint.
• Only Cool setpoint is shown.
• Up/Down arrows change Cool setpoint.
• Both Cool and Heat setpoints are
shown.
• Up/Down arrows increase or decrease
values by the same amount.
• The program mode is active as indicated by
the return annotation.
• The Time of Day annotation is not
displayed in the other four modes (Off,
Heat, Cool or Auto).
• Both Cool and Heat setpoints are shown.
• Up/Down arrows increase or decrease
values by the same amount.
• When the thermostat moves to the next
time period, the setpoints will be adjusted
accordingly.
Note:
• To adjust the gap between the setpoints in Auto mode, press Mode to select Heat and set the
temperature you desire. Press Mode to select Cool and set the temperature you desire.
Press Mode to return to Auto; the settings will reflect your changes.
• If you set Heat and Cool to the same temperature, Heat will automatically move down 2° (the
minimum allowable gap).
