A SERVICE OF

logo

Figure E-S. Tractor release levers
Loading Continuous Paper
Once you have installed the tractor and separator, the printer
is ready to accept continuous paper.
To do this you first need to adjust the printer.
Check that the DIP switch under the dust cover (SW-4 as de-
scribed in Appendix D) is in the OFF position. This switch must
be off except when the optional cut-sheet feeder is installed.
Push back the paper separator so that it’s in a raised position
on the back of the printer (see Figure E-6).
Next, pull the paper friction lever forward to move the paper
pressure bar away from the platen.
E-4