Figure 1-1. Continuous paper feeding
Selecting the Right Location
To make sure you’ve picked a satisfactory location for your
SQ-2000, keep the following points in mind.
The location should be:
l A flat, stable surface with enough room for continuous paper
feed as shown in the illustration.
l Served by an electrical outlet that cannot be turned off
accidentally by a wall switch or similar switch.
l Out of direct sunlight and not exposed to grease or dust.
l Away from electrical interference from motors and high vol-
tage power lines.
l Not subject to temperatures below 41°F (5°C) or above 95°F
(35°C) when the printer is operating.
l Not subject to either extremely high or extremely low
humidity.
If your location meets these conditions, you’re ready to begin
setting up your new printer.
6
