To reset the tear-off position, press the
Tear Off button to enter tear-off mode and
feed the paper to the tear-off position.
Then use the Micro Feed buttons to move
the paper to the desired position. See
“Adjusting the tear-off position” in
Chapter 3.
To adjust the printing position, press
either Micro Feed button to advance or
reverse the paper to the desired position.
See “Adjusting the printing position” in
Chapter 3.
c
Caution:
When labels are loaded, use only the top Micro Feed
button. Never feed labels backward through the printer.
Pause
Press to temporarily stop printing. Press
again to resume printing.
Hold down for at least 3 seconds to reset
the printer’s control panel settings.
Tractor Select
Front/Rear
Selects the front or rear tractor. If you have
been using paper loaded on one tractor, first
remove the printed output before pressing
this button to switch the tractor. When you
switch between tractors, the paper already
loaded in the printer is fed backward to the
standby position, and the paper on the
newly selected tractor is loaded.
c
Caution:
Never use the Front/Rear button when labels are loaded
in the printer. Always tear off any printed pages or excess
paper so you don’t feed more than one page backward
through the printer.
4
R
Peony Rev.C
A5 size Chapter 4
98/01/07 Pass 4
Using the Printer
4-7
