T Turn on auto cut mode with DIP switch 3-7; the perforation
cutter will cut off each page automatically. See “Using DIP
Switches” in Chapter 4.
T Select the printer’s tear-off mode as follows:
1. Make sure printing has finished. Open the paper separator
cover. You see the perforation cutter’s tear-off edge.
2. Press the
Tear Off
button to enter tear-off mode. The printer
feeds the paper’s perforation to the perforation cutter’s
tear-off edge.
3. If the paper is not aligned with the tear-off edge, adjust the
tear-off position by pressing the
Micro Feed
buttons.
4. Press the
Tear Off
button again. The printer cuts off your
printed document and feeds the fresh paper back to the
top-of-form position.
Switching tractors
To switch tractors when the perforation cutter is installed,
follow these steps:
1. Make sure the printer is turned on. If you are in the middle
of printing a document, wait for the printer to finish
printing before you switch tractors.
2. If no paper is loaded in the tractor you want to use, load
paper as described in Chapter 3.
3. Press the Front/Rear button to switch to the other tractor.
The printer cuts off the printed document, feeds the paper
on the tractor backward to the standby position, and then
advances the paper on the other tractor to the loading
position.
6
R
Peony Rev.C
A5 size Chapter 6
98/01/07 Pass 4
Using Printer Options 6-19
