Epson 4004677 Manual

A SERVICE OF

next previous

8. Change the linear spacers (2 spacers for the monochrome head only) with new ones, referring

the figure below. (Replace linear spacers using tweezers to push the head base toward the

rear.)

9. Rerun the BASIC program, and choose the “Head Vertical Position Confirmation” by typing 3

and ENTER; then confirm that the sample print is correct. If the sample is incorrect, change the

thickness of the linear spacer and perform this adjustment again until the two black and

magenta lines are aligned at the position “OK (0).”

10. When you complete this adjustment, exit the BASIC program and turn off the printer.

1: Push

Carriage Unit

Platen Gap

Adjust Lever

2: Replace

Black Head

Head Base

Linear Spacer x 2

(Linear Spacer

Replacement Position)

Angular Spacer

Figure 4-11. Linear Spacer Replacement Method

Stylus Pro XL Adjustments

Rev. A 4-11