Epson 4004677 Manual

A SERVICE OF

next previous

7. Turn the printer power off now.

8. Manually move the carriage to the center while pressing the carriage lock lever, and remove

the two ink cartridges.

9. Remove the rubber cap covering the head screw at the side of color ink cartridge. Then loosen

(but do not remove) 3 screws. (Refer to Figure 4-6.)

WARNING

After replacing the spacer, always install new ink cartridges before returning the printer to

the user. During this adjustment, use ink cartridges exclusively for service (Monochrome:

1020626, CMY: 1020627). You can reuse old ink cartridges for other purposes.

10. Replace the angular spacer for the black head with a new one, referring Figure 4-7.

(Replace the angular spacer by using tweezers to push the head base toward the rear.)

1: Push

Carriage Unit

Platen Gap

Adjust Lever

Linear Spacer

Black Head

Head Base

Angular Spacer

2: Replace

(Angular Spacer

Replacement Position)

Figure 4-6. Removing the Rubber Cap

Stylus Pro XL Adjustments

Rev. A 4-7