PowerConnect B-Series FCX Configuration Guide 1247
53-1002266-01
Displaying 802.1X information
34
Enabling 802.1X accounting
To enable 802.1X accounting, enter the following command.
PowerConnect(config)#aaa accounting dot1x default start-stop radius none
Syntax: aaa accounting dot1x default start-stop radius | none
radius – Use the list of all RADIUS servers that support 802.1X for authentication.
none – Use no authentication. The client is automatically authenticated without the device using
information supplied by the client.
If you specify both radius and none, make sure radius comes before none.
Displaying 802.1X information
You can display the following 802.1X-related information:
• The 802.1X configuration on the device and on individual ports
• Statistics about the EAPOL frames passing through the device
• 802.1X-enabled ports dynamically assigned to a VLAN
• User-defined and dynamically applied MAC address filters and IP ACLs currently active on the
device
• The 802.1X multiple-host configuration
Displaying 802.1X configuration information
To display information about the 802.1X configuration on the Dell PowerConnect device, enter the
following command.
Syntax: show dot1x
The following table describes the information displayed by the show dot1x command.
PowerConnect#show dot1x
PAE Capability: Authenticator Only
system-auth-control: Enable
re-authentication: Disable
global-filter-strict-security: Enable
quiet-period: 60 Seconds
tx-period: 30 Seconds
supptimeout: 30 Seconds
servertimeout: 30 Seconds
maxreq: 2
re-authperiod: 3600 Seconds
Protocol Version: 1
