Configuring System Information 251
The File Upload to Server page contains the following fields:
•
Supported IP Format
— Specifies the IP format supported by the server. The possible values are:
–
IPv6
— IP version 6 is supported.
–
IPv4
— IP version 4 is supported.
•
IPv6 Address Type
— When the server supports IPv6 (see previous parameter), this specifies the type
of static address supported. The possible values are:
–
Link Local
— A Link Local address that is non-routable and used for communication on the same
network only.
–
Global
— A globally unique IPv6 address; visible and reachable from different subnets.
•
Link Local Interface
— When the server supports an IPv6 Link Local address (see previous
parameter), this specifies the the Link Local interface. The possible values are:
–
VLAN1
— The IPv6 interface is configured on VLAN1.
–
ISATAP
— The IPv6 interface is configured on ISATAP tunnel.
•
Firmware Upload
— The Firmware file is uploaded. If
Firmware Upload
is selected, the
Configuration Upload
fields become unavailable.
•
Configuration Upload
— The Configuration file is uploaded. If
Configuration Upload
is selected,
the
Software Image Upload
fields become unavailable.
•
Upload via TFTP
—
Enables initiating an image upload via the TFTP server.
•
Upload via HTTP
—
Enables initiating an image upload via the FTP server.
Software Image Upload
•
TFTP Server IP Address
— The TFTP Server IP Address to which the Software Image is uploaded.
•
Destination File Name (1-64 Characters)
— Indicates the Software Image file path to which the file is
uploaded.
