724-746-5500 | blackbox.com
724-746-5500 | blackbox.com
Page 97
LGB5028A User‘s Manual
Chapter 6: Configuration
6.8.2 LLDP Neighbors
This page provides a status overview for all LLDP neighbors. The displayed table contains a row for each port on which an LLDP
neighbor is detected. The columns hold the following information:
Web Interface
To show LLDP neighbors:
1. Click “LLDP Neighbors.”
2. Click “Refresh” for manual update Web screen.
3. Click “Auto-refresh” for auto-update Web screen.
Figure 6-42. The LLDP Neighbor Information screen.
NOTE: If your network without any device supports LLDP then the table will show “No LLDP neighbor information found.”
Parameter Description
Local Port: The port on which the LLDP frame was received.
Chassis ID: The Chassis ID is the identification of the neighbor’s LLDP frames.
Remote Port ID: The Remote Port ID is the identification of the neighbor port.
System Name: System Name is the name advertised by the neighbor unit.
Port Description: Port Description is the port description advertised by the neighbor unit.
System Capabilities:
System Capabilities describes the neighbor unit’s capabilities. The possible capabilities are:
1. Other
2. Repeater
3. Bridge
4. WLAN Access Point
5. Router
6. Telephone
7. DOCSIS cable device
8. Station only
9. Reserved
When a capability is enabled, the capability is followed by (+). If the capability is disabled, the capability is followed by (-).
System Description: System Description is the port description advertised by the neighbor unit.
