Filter
Top Products
5-34
STARTER CLUTCH AND GENERATOR
ENG
CAUTION:
NOTE:
NOTE:
5. Remove:
Sgenerator rotor
1
(with the flywheel puller
2
and flywheel pull-
er attachment)
Swoodruff key
To protect the end of the crankshaft, place
an appropriate sized socket between the fly-
wheel puller set’s center bolt and the crank-
shaft.
Make sure the flywheel puller is centered over
the generator rotor.
Flywheel puller
90890-01362, YU-33270
Flywheel puller attachment
90890-04089, YM-33282
REMOVING THE STARTER CLUTCH
1. Remove:
Sstarter clutch bolt
1
SWhile holding the generator rotor with the
sheave holder, remove the starter clutch bolt.
SDo not allow the sheave holder to touch the
projection on the generator rotor.
Sheave holder
90890-01701, YS-01880-A