Filter
Top Products
3-64
CHECKING AND CHARGING THE BATTERY/
CHECKING THE FUSES
CHK
ADJ
CAUTION:
CAUTION:
NOTE:
6. Install:
Sbattery
7. Connect:
Sbattery leads
(to the battery terminals)
First, connect the positive battery lead
1
,
and then the negative battery lead
2
.
8. Check:
Sbattery terminals
Dirt ! Clean with a wire brush.
Loose connection ! Connect properly.
9. Lubricate:
Sbattery terminals
Recommended lubricant
Dielectric grease
10. Install:
Srider seat
Refer to “SEATS”.
EAS00181
CHECKING THE FUSES
The following procedure applies to all of the
fuses.
To avoid a short circuit, always set the main
switch to “OFF” when checking or replacing
a fuse.
1. Remove:
Sfront cowling inner panel (left)
Refer to “COWLINGS”.
Srider seat
Refer to “SEATS”.
2. Check:
Sfuse
a. Connect the pocket tester to the fuse and
check the continuity.
Set the pocket tester selector to “Ω 1”.