Filter
Top Products
8-43
8
7. Start the engine and rev it up approximately
twenty times while momentarily creating ex-
haust system back pressure by blocking the
end of the muffler with a shop towel.
8. Stop the engine and allow the exhaust pipe to
cool.
9. Install the purging bolt and tighten it to the
specified torque.
WARNING
EWB01930
EBU23930
V-belt case drain plug
After riding in water deep enough to allow it to en-
ter the V-belt case, remove this plug to drain the
water from the case.
1. Purging bolt
Tightening torque:
Purging bolt:
27 Nm (2.7 m·kgf, 19 ft·lbf)
POTENTIAL HAZARD
Improperly purging the exhaust system.
Hot exhaust system.
WHAT CAN HAPPEN
Could injure the eyes.
Could cause burns.
Could cause carbon monoxide poisoning,
possibly leading to death.
Could start a fire.
HOW TO AVOID THE HAZARD
When purging the exhaust system:
Always let the exhaust system cool prior to
touching exhaust components.
Always wear eye protection, and make sure
no one is behind the ATV.
Never run the engine in an enclosed area.
Make sure there are no combustible materi-
als in the area.
U28P10E0.book Page 43 Thursday, April 10, 2008 9:29 AM