Filter
Top Products
Periodic maintenance and adjustment
105
4. Unhook the bulb holder, and then remove
the burnt-out bulb.
5. Install a new bulb, and then hook the bulb
holder onto the headlight unit. NOTICE:
Keep oil and your hands away from
the glass part of the bulb or its life and
illumination will be affected. If the
glass is oil stained, thoroughly clean it
with a cloth moistened with alcohol or
lacquer thinner.
[ECS00621]
6. Install the bulb holder cover, and then
connect the headlight coupler.
7. Close the shroud.
RST90GT
1. Remove the shroud and the top cover.
(See page 63 for removal procedures.)
2. Remove the headlight unit bolt and the
windshield stay bolts on each side of the
snowmobile.
3. Unhook the headlight unit as shown, then
lift it up and move it forward, away from
the handlebar. NOTICE: Be careful not
to scratch the snowmobile when mov-
ing the headlight unit.
[ECS00920]
1. Headlight coupler
2. Bulb holder cover
1. Bulb holder
1
2
1. Do not touch the glass part of the bulb.
Bulb type:
Halogen bulb
1. Headlight unit bolt
2. Windshield stay bolt
1
1
2
U8JA11E0.book Page 105 Monday, June 14, 2010 10:22 AM