Filter
Top Products
Periodic maintenance and adjustment
66
Top cover (RST90GT)
To remove the top cover
1. Remove the shroud and the left side cov-
er. (See the above procedures.)
2. Disconnect the auxiliary DC jack coupler.
3. Open the zippers on the left and right
sides of the handlebar cover, and then re-
move the cover.
4. Pull the windshield stay rubber covers
upward.
5. Loosen the quick fastener screws.
6. Lift up the rear of the top cover, discon-
nect the main switch coupler, and then
remove the cover.
To install the top cover
1. Connect the main switch coupler.
2. Place the top cover in the original posi-
tion, making sure to fit the projections on
the cover into the slots in the headlight
unit.
1. Auxiliary DC jack coupler
1. Handlebar cover
2. Quick fastener screw
1
1
22
1. Windshield stay rubber cover
1. Top cover
2. Main switch coupler
1
1
2
U8JA11E0.book Page 66 Monday, June 14, 2010 10:22 AM