Filter
Top Products
Periodic maintenance and adjustment
91
9. Tighten the V-belt position adjusting
bolts.
10. Install the V-belt over the primary sheave
assembly.
11. Rotate the secondary sliding sheave
clockwise and push it so that it separates
from the secondary fixed sheave.
12. Install the V-belt between the secondary
sliding and fixed sheaves.
13. Place the left lower cover in the original
position, and then install the screws and
the bolts. (RS90P / RS90PLT /
RST90PGT).
RS90P / RS90PLT / RST90PGT
14. Install the drive guard, and then install the
left side cover and the shroud (RS90P /
RS90PLT / RST90PGT), or close the
shroud (RST90).
ESU13923
Drive chain housing
To check the drive chain housing oil
level
1. Place the snowmobile on a level surface
and apply the parking brake.
2. Remove the shroud and the right side
cover (RS90P / RS90PLT / RST90PGT),
or open the shroud (RST90). [See page
63 (RS90P / RS90PLT / RST90PGT) or
page 67 (RST90) for the procedures.]
3. Remove the dipstick, wipe it off with a
clean rag, and then insert it back into the
filler hole.
RS90P / RS90PLT / RST90PGT
V-belt position adjusting bolt tightening
torque:
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
1. Secondary sliding sheave
2. Secondary fixed sheave
1. V-belt
1. Left lower cover
1. Dipstick
1
1
U8HV10E0.book Page 91 Monday, May 16, 2011 1:15 PM