Filter
Top Products
Periodic maintenance and adjustment
72
7. Tighten the locknut.
8. Install the headlight unit, making sure to
fit the slots on its bottom onto the projec-
tions on its stay.
9. Fit the weatherstrip on the headlight unit
into the recess in the top of the air filter
case cover.
10. Install the headlight unit bolts and wind-
shield stay bolts, and then tighten them to
their specified torques.
11. Install the top cover and the shroud.
ESU11863
Checking the throttle override
system (T.O.R.S.)
WARNING
EWS00352
When checking the T.O.R.S., take precau-
tions to avoid snowmobile movement
which could cause an accident:
● Make sure that the throttle lever moves
smoothly with the engine off before
checking the T.O.R.S.
● Make sure that the parking brake is ap-
plied.
● Do not rev the engine to the point that
the clutch engages.
1. Locknut
2. Throttle lever free play adjusting bolt
3. Throttle lever free play
Throttle lever free play:
2.0–3.0 mm (0.08–0.12 in)
1. Slot
2. Projection
3
2
1
(a)
(b)
1
2
1. Weatherstrip
Tightening torques:
Headlight unit bolt:
3.0 Nm (0.30 m·kgf, 2.2 ft·lbf)
Windshield stay bolt:
14 Nm (1.4 m·kgf, 10 ft·lbf)
1
U8HV10E0.book Page 72 Monday, May 16, 2011 1:15 PM