Filter
Top Products
Control functions
24
Rebound damping force
The rebound damping force of each shock
absorber can be adjusted by turning its re-
bound damping force adjusting knob.
To increase the rebound damping force, turn
the adjusting knob in direction (a). To de-
crease the rebound damping force, turn the
adjusting knob in direction (b).
FX10RTRS
FX10XT
TIP
The damping forces will not decrease past the
minimum levels even if the adjusting knobs
are turned out more than the minimum set-
tings.
ESU13132
Adjusting the spring preload of the
center shock absorber and the rear
torsion springs
The spring preload can be adjusted by turning
the adjusting nut on the center shock absorb-
er and the adjusters on the rear torsion
springs. Adjust the spring preload as follows.
Compression damping setting:
Minimum (soft):
FX10RTRS 19
FX10XT 12
click(s) in direction (b)*
Standard:
FX10RTRS 10
FX10XT 6
click(s) in direction (b)*
Maximum (hard):
FX10RTRS 7
FX10XT 2
click(s) in direction (b)*
* With the adjusting knob fully turned in
direction (a)
1. Rebound damping force adjusting knob
1. Rebound damping force adjusting knob
Rebound damping setting:
Minimum (soft):
FX10RTRS 19
FX10XT 20
click(s) in direction (b)*
Standard:
FX10RTRS 10
FX10XT 11
click(s) in direction (b)*
Maximum (hard):
FX10RTRS 1
FX10XT 3
click(s) in direction (b)*
* With the adjusting knob fully turned in
direction (a)
U8HK10E0.book Page 24 Tuesday, June 10, 2008 1:58 PM