Filter
Top Products
Control functions
8
ESU10292
Main switch
The main switch controls the ignition and
lighting systems. The various positions are
described below.
Off
The ignition circuit is switched off.
The key can be removed only in this position.
On
The ignition circuit is switched on.
Start
The starting circuit is switched on.
The starter motor cranks the engine.
NOTICE: Release the switch immediately
after the engine starts.
[ECS00021]
TIP
The headlights and taillight come on after the
engine is started.
ESU10312
Throttle lever
Once the engine is running cleanly, squeez-
ing the throttle lever will increase the engine
speed and cause engagement of the drive
train. Regulate the speed of the snowmobile
by varying the throttle position. Because the
throttle is spring-loaded, the snowmobile will
decelerate, and the engine will return to idle
when it is released.
ESU10321
Engine overheating prevention
system
This model is equipped with a system, which
prevents overheating when the engine is
idling.
When the engine has been idling for 3 min-
utes or longer and the coolant temperature
has risen above 100 °C (212 °F), the engine
automatically stops to prevent overheating.
TIP
The engine can be started after it stops.
ESU10345
Throttle override system
(T.O.R.S.)
WARNING
EWS00041
If the T.O.R.S. is activated, make sure that
the cause of the malfunction has been cor-
rected and that the engine can be operated
without a problem before restarting the
engine. Continuing to operate with a mal-
function could cause loss of control or
damage.
If the throttle bodies or throttle cable malfunc-
tions during operation, the T.O.R.S. will oper-
ate when the throttle lever is released.
The T.O.R.S. is designed to override the fuel
injection and limit the engine speed to less
than the clutch engagement speed if the throt-
1. Off
2. On
3. Start
1. Throttle lever
U8HK10E0.book Page 8 Tuesday, June 10, 2008 1:58 PM