Filter
Top Products
Control functions
10
● a digital speedometer (which shows the
riding speed)
● an odometer (which shows the total dis-
tance traveled)
● a tripmeter (which shows the distance trav-
eled since it was last set to zero)
● an engine speed meter (which shows the
engine speed; not for use while riding)
● warning indicators (which show self-diag-
nosis, coolant temperature, fuel level, and
oil level warnings)
● indicator lights (which show high beam and
low coolant temperature conditions)
● a warning light (which shows warnings to-
gether with the warning indicators)
● a fuel meter (which shows the fuel remain-
ing in the fuel tank)
● a grip/thumb warmer level indicator (which
shows the grip warmer or the thumb warm-
er level)
When the key is turned to the on position, the
warning light, the low coolant temperature in-
dicator light, and all segments of the meter
display come on and go off.
The grip warmer level is initially displayed for
5 seconds, then the display switches to the
fuel meter.
Odometer, tripmeter, and engine
speed meter modes
Pushing the “SELECT” button switches the
display between the odometer mode “ODO”,
tripmeter mode “TRIP”, and engine speed
meter mode “r/min”.
To reset the tripmeter, push the “RESET” but-
ton for at least 1 second while the tripmeter is
displayed.
TIP
● To switch the speedometer, odometer, and
tripmeter displays between kilometers and
miles, select the odometer mode “ODO”,
and then push the “SELECT” button for at
least 10 seconds while the snowmobile is
stopped.
● Use the engine speed meter only when
checking the snowmobile and performing
basic maintenance. The engine speed
meter should not be used while riding the
snowmobile since the reading will vary from
the actual engine speed.
ESU10410
High beam indicator light “”
The high beam indicator light comes on when
the high beams of the headlights are switched
on. (See page 14 for headlight beam switch
operation.)
1. Warning light “”
2. Low coolant temperature indicator
light “”
3. Meter display
1. “SELECT” button
2. “RESET” button
U8HK10E0.book Page 10 Tuesday, June 10, 2008 1:58 PM