Filter
Top Products
PERIODIC MAINTENANCE AND ADJUSTMENT
7-36
7
3. Remove the burnt-out bulb by pull-
ing it out.
4. Insert a new bulb into the socket.
5. Install the socket (together with the
bulb) by pushing it in.
6. Install the license plate light unit by
installing the screws.
EAU24360
Front wheel
EAU40201
To remove the front wheel
WARNING
EWA10821
To avoid injury, securely support the
vehicle so there is no danger of it
falling over.
1. Place the vehicle on the center-
stand.
2. Loosen the front wheel axle pinch
bolt, then the wheel axle and the
brake caliper bolts.
3. Remove the brake hose holder on
each side by removing the bolt and
nut.
4. Remove the brake caliper (togeth-
er with the reflector) on each side
by removing the bolts. NOTICE:
Do not apply the brake after the
brake calipers have been re-
moved, otherwise the brake
pads will be forced shut.
[ECA11051]
5. Pull the wheel axle out, and then
remove the wheel.
1. License plate light bulb
1. Front wheel axle pinch bolt
2. Wheel axle
3. Brake caliper bolt
3
2
1
1. Brake hose holder
2. Bolt and nut
3. Brake caliper bolt
4. Brake caliper
5. Reflector
U1CA10E0.book Page 36 Tuesday, November 24, 2009 1:41 PM