Filter
Top Products
INSTRUMENT AND CONTROL FUNCTIONS
4-17
4
EAU47350
Helmet holder
The helmet holder is located under the
passenger seat. A helmet holding cable
is provided in the owner’s tool kit to se-
cure a helmet to the helmet holder.
To secure a helmet to the helmet
holder
1. Remove the passenger seat. (See
page 4-13.)
2. Pass the helmet holding cable
through the buckle on the helmet
strap as shown, and then hook the
cable loop over the helmet holder.
3. Place the helmet on the right side
of the vehicle, and then install the
passenger seat. WARNING! Nev-
er ride with a helmet attached to
the helmet holder, since the hel-
met may hit objects, causing
loss of control and possibly an
accident.
[EWA10161]
To release the helmet from the hel-
met holder
Remove the passenger seat, remove
the helmet holding cable from the hel-
met holder and the helmet, and then in-
stall the passenger seat.
EAU14462
Storage compartment
The storage compartment is located
under the passenger seat. (See page
4-13.)
WARNING
EWA10961
● Do not exceed the load limit of 3
kg (7 lb) for the storage com-
partment.
● Do not exceed the maximum
load of FZ6RZ 189 kg (417 lb)
FZ6RZC 187 kg (412 lb) for the
vehicle.
When storing the Owner’s Manual or
other documents in the storage com-
partment, be sure to wrap them in a
plastic bag so that they will not get wet.
1. Helmet holder
2. Owner’s tool kit
3. Helmet holding cable
3
1
2
1. Helmet
2. Helmet holding cable
3. Helmet holder
1
2
3
1. Storage compartment
1
U36P11E0.book Page 17 Tuesday, September 29, 2009 5:12 PM