Filter
Top Products
COMMUNICATION BREAKDOWN
Communication Breakdown
If a problem arises between the control panel and the
laser/radar antenna, the unit will give a unique audio tone,
and the B/L will go to full brightness.
The display shows:
Trouble w/ Radar Antenna Trouble w/ Temp Probe
If a COM error occurs:
• Press
P/V to turn unit off.
• Check connection in back of control panel.
• Perform “reset features.”
• See dealer/installer.
If a T error occurs:
• Press
P/V to turn off unit.
• Check temperature probe installation for possible
pinched wire.
• See dealer/installer.
NOTE: This T error occurs only at Power Up.
19
RESET FEATURES/CARE & MAINTENANCE
18
Reset Features
All user features can be reset to factory settings.
• Remove Power from unit.
• Press and hold P/V and Quiet.
• Apply power to the unit.
• Wait for 2 beeps.
• Release P/V and Quiet. Unit is now reset to the following
features and settings.
1. Audio to level (5).
2. Set to Highway Mode.
3. B/L to DIM-BRT.
4. Auto Quiet Mode OFF.
5. VG-2 Detection Mode OFF.
6. Voice OFF.
7. POP
™
Mode ON.
8. Safety Radar OFF.
9. Full Power Up sequence.
10. Default TONE 3.
11. BATT ON.
12. TEMP ON.
13. LED ON.
14. TONE OFF.
15. TEMP to “F”.
16. WIHD set to BRT
Care And Maintenance
Do not spray water, cleaners or polishes directly onto the unit.
Keep the laser-radar lens clean for optimum performance.
Also, do not use any abrasive cleaners on the unit’s exterior.