182
Maintenance and service
Replacing bulbs
– Twist the bulb holder anticlockwise and
withdraw it.
– Replace the bulb.
– Fit the bulb holder in place and twist it
clockwise.
– Refit the speaker and press in the red tab.
– Press the speaker grille back into
position.
NOTE! If the error message "Bulb Failure"/
"Check brake light" remains after a faulty bulb
has been replaced then an authorised Volvo
workshop needs to be consulted to rectify
the fault.
Number plate lighting
– Switch off all lights and turn ignition the
key to position 0.
– Remove the screw with a screwdriver.
– Loosen the whole lamp housing carefully
and pull it out.
– Turn the connector anticlockwise and pull
out the bulb.
– Replace the bulb.
– Refit the contact and turn clockwise.
– Refit the entire lamp housing and screw it
into place.
.
Courtesy lighting
There is courtesy lighting under the dash-
board on the driver and passenger sides.
– Insert a screwdriver and gently turn so
that the lamp housing comes loose.
– Remove the bulb.
– Fit a new bulb.
– Refit the lamp housing.