Filter
Top Products
12
Loosen two sunshade fixing screws.
Turn the sunshade,
then extract it.
2. Connect the camera’s monitor output terminal to the monitor.
Note: The camera will not operate if the monitor output terminal is connected to the camera drive unit.
3. Switch on the power supply. The power is supplied to the camera, permitting the camera images to be
viewed on the monitor.
4. Set each mode setting switch to the position that provides the best picture reproduction.
• If flicker may cause a nuisance, turn the Flickerless switch to ON.
• If the camera images will be too dark, turn the Backlight compensation switch to ON.
Note: For the details, refer to p. 15, “About mode setting switch.”
Turn the front cover in
the direction indicated
by the arrow to remove.
Front cover
[Removing sunshade]
[Removing the front cover]
6. ADJUSTMENT
1. After completing camera unit installation and connections, remove both the sunshade and front cover.