Filter
Top Products
Page 14 USSC
18. Installing steel smoke shield. Two (2) holes are
provided above each corner of the feed door.
Slide the two (2) bolts, supplied in the parts bag,
into the holes. Next, place the two (2) clips pro-
vided onto each bolt and then attach the two
(2) nuts on each bolt. Before tightening the bolts
and nuts securely, slide the smoke shield up un-
der the clips, lining them with the slots in the smoke
shield. Tighten the (2) bolts and nuts. (NOTE: The
smoke shield should be able to swing back and
forth.) The smoke shield will help prevent smoke
back puffing if you have a lazy flue.
17. To install Feed Door handle, insert handle into the
door then attach with the 1/2-13 nut and washer
provided. Tighten nut against the backside of
the door then back it off approx. 1/4 turn or until
handle moves freely.
(Follow these instructions
for ash door handle installation.)
ASSEMBLASSEMBL
ASSEMBLASSEMBL
ASSEMBL
Y ILLY ILL
Y ILLY ILL
Y ILL
USTRAUSTRA
USTRAUSTRA
USTRA
TIONSTIONS
TIONSTIONS
TIONS
18. Find the Feed Door Latch shown in the parts box.
Install with the 1/4-20 bolts and nuts provided.
Adjust the latch so that the door seals properly.
(The ash door latch shall be assembled in the same
manner using the ash door latch.)
19. To install the dampers on the doors, screw the
damper up onto the 1/2-13 carriage bolt pro-
vided. Then screw the damper and bolt into the
door until the bolt protrudes the rear of the door
so that a nut can be attached. Tighten the nut.