TomTom 4CQ02 GPS Receiver User Manual


 
Read me first2.
3
Read
me first
EasyClick mount
Use the EasyClick mount to install your TomTom GO inside your car.
Make sure that both the EasyClick mount and your windscreen are clean and dry before
you attach the mount. Place the EasyClick mount so that it does not interfere with your
view of the road or of any of the controls in your car.
To attach the EasyClick mount, press the suction cup firmly against the windscreen on an
area where the glass is flat. Then twist the rubber grip near the base of the mount in a
clockwise direction until you hear a click.
Plug the cable into your car dashboard and connect the other end to the bottom of your
device.
Switching on and off
To switch on your navigation device, press and hold the On/Off button until you see the
start-up screen. The first time you switch on your device, it may take a short time to start.
Setting up
Important: Take care to select the correct language, since the language you choose will
be used for all menus and written instructions.
When you first switch on your device, you have to answer a few questions to set up the
device. Answer the questions by tapping the screen.
GPS reception
When you first start your TomTom GO navigation device, the device may need a few min-
utes to determine your GPS position and show your current position on the map. In future,
your position will be found much faster, usually within a few seconds.
To ensure good GPS reception, you should use your device outdoors. Large objects such
as tall buildings can sometimes interfere with reception.
About MyTomTom
MyTomTom helps you manage the contents and services of your TomTom GO navigation
device, as well as giving you access to the TomTom community. You log in to MyTomTom
on the TomTom website. It is a good idea to frequently connect your navigation device to
MyTomTom, to ensure you always have the latest updates.