Filter
Top Products
730 Bubbler Module
Section 2 Programming the Module
2-3
Figure 2-2 Sampler Programming: 730 Module Screens
SELECT UNITS FOR
FLOW VOLUME:
cf gal Mgal
m3 lit
6712 SAMPLER
EXTENDED PROGRAMMING
FOR HELP AT ANY
SCREEN PRESS ? KEY
RUN
PROGRAM
VIEW REPORT
OTHER FUNCTIONS
MODULE INSERTED--
DOWNLOAD DATA NOW
OR LOSE ALL DATA!
DONE
6712 SAMPLER
STANDARD PROGRAMMING
FOR HELP AT ANY
SCREEN PRESS ? KEY
SITE DESCRIPTION
"FACTORY"
CHANGE?
YES NO
SELECT UNITS FOR
FLOW RATE:
cfs gps gpm Mgd
lps m3s m3h m3d
RUN "EXTENDED 1'
PROGRAM
VIEW REPORT
OTHER FUNCTIONS
PROGRAM NAME"
"EXTENDED 1"
CHANGE?
YES NO
See
sampler
manual.
See
sampler
manual.
Standard
Extended
INTERVAL CHANGED --
DOWNLOAD DATA NOW
OR LOSE ALL DATA!
DONE
NEW MODULE SETUP --
DOWNLOAD DATA NOW
OR LOSE ALL DATA!
DONE
__.__ ft
ARE YOU SURE?
YES NO
DATA STORAGE
INTERVAL IN MINUTES
1 2 5
10 15 30
CURRENT LEVEL IS
__.__ ft
ADJUST LEVEL TO
__.__ ft
Continue with sampler programming sequence
(see sampler manual).
If applicable. This screen appears
only when a selection is changed.
Selecting NO will cause the sampler
to not accept the module setup changes.
If applicable. This screen
appears only when the interval
is changed. If NO was selected
the storage interval will not change.
PROGRAM MODULE?
YES NO
NO
YES
If applicable. This screen appears only
when the adjustment differs from the
current reading by more than 0.5 ft.
Note:
To program the module or
run a program that requires
a module, you must plug in
the module before turning
on the 6712 controller.
This screen appears only when a module has been
changed or if the module was unplugged while
the sampler was powered. If NO is selected,
the sampler responds as if there is no module.
SELECTED UNITS FOR
LENGTH:
ft m
See Figure 2-3, Module Setup.