Filter
Top Products
2-1
730 Bubbler Module
Section 2 Programming the Module
2.1 Module Screens When the controller is configured with the module, it adds the
necessary screens for programming. The screens appear on the
following pages in Figures 2-2 through 2-4. These figures outline
the steps for module programming and calibration. For 6712 pro-
gramming and general programming information refer to the
sampler manual.
2.2 Programmed Enable When the 730 Module is installed, additional sampler enable
options are available. If programmed for LEVEL ONLY the
option will be LEVEL. If programmed for FLOW METER the
options will be LEVEL and FLOW. For more information about
programmed enables, refer to the sampler manual.
2.3 Data Storage When the sampler is configured for use with the module, a
memory partition is reserved. The module readings are stored in
this sampler memory partition. For more information on data
storage and partition management, see the sampler manual.
2.3.1 Recovering Module
Data
The stored module data can be collected or viewed as “reports.”
Three of the sampler reports contain module information, and
are shown in Figure 2-1. Refer to the Sampler Instruction
Manual for collecting and reading the reports.
Note
An * (asterisk) appears next to the reading if the module was
unable to take a reading. If an asterisk appears, the reading
displayed is the last available reading.