Filter
Top Products
Page 14
INSTALLATION MANUAL REMOTE VEHICLE STARTER
System Reset
Quick View Programming
* See the following pages for more detailed programming instructions.
Menu 1 -Press Lock 1 Flash 2 Flashes 3 Flashes
1 Ignition Lock Enabled Lock Only Disabled
2 Horn Honk Type 1 Type 2 All Honks
3 Lock&Unlock Double Unlock 3 second .75 second
4 Unlock/Disarm 125ms 750ms
5 Auxiliary Outputs Type 1Type 2 Disabled
Menu 2 -Press Unlock 1 Flash 2 Flashes 3 Flashes
1 Secure Service Mode 15 seconds 5 seconds
2 Park Light Output 30 second (-) Park Light Park Light Flash
3 Horn Timing 5ms 50ms 10ms
4N/A
5 Reservation Mode Manual Auto Reservation
Menu 3 -Press Start 1 Flash 2 Flashes 3 Flashes
1 Lock/ Unlock Type Type 1 Type 2 Normal
2 Gas/ Diesel Negative 15 second Gas/ Positive
3 Rearm Output Type 1 Type 2 Rearm
4RunTime 4Min 45Min 15 Min
5 Crank Time 10 second 3 seconds 5 seconds
6 Starter Disable/ GWR Active Passive GWR
7 Safety Start Mode Press twice Press once
Menu 4 -Press # 1 Flash
1 Low Idle Learn Low Idle Learn
2 Adjust For Over Crank Reduced by 10%
3 Adjust For under Crank Increased by 10%
**Bold type indicates settings that are Factory Default.
The system reset will clear any changes made to the Program Menu’s as well as the
Tach setting. When the system reset is complete the system must be Tach learned
before the remote starter will operate.
1) Turn the ignition key from “Off” to “On” 3 times, ON-OFF-ON-OFF-ON within three
seconds. (Leave the key in the ON position)
2) Press and release the Program Button located on the antenna. The park lights will
turn on and the horn (optional) will honk one time.
3) Then press and hold the Program Button until the park lights flash and the horn
(optional) will honk 3 times slowly to confirm system reset.
System is now reset to factory defaults.
Note: System Reset does not delete the transmitter codes from memory.