Filter
Top Products
Page 12
INSTALLATION MANUAL REMOTE VEHICLE STARTER
Important Tach Notes
Tach Learning the remote starter is one of the most important steps in the installation
process. Do not tach learn vehicle while the engine is in high idle. To ensure the best
possible tach setting, ensure that the vehicle is at low idle/ normal operating RPM.
Vehicles such as Toyota and Honda may idle much higher when the engine is warm
compared to starting the vehicle when the engine is cold. The Quick Learn feature may
be used to tach learn the vehicle again but at a normal engine RPM.
Quick learn Tach
BRAKE
BRAKE
Start the
vehicle with
the key.
Hold the
brake pedal.
Press and release
the program button,
then press and hold.
Quick Learn Tach is designed to re-learn the remote starters tach setting while the
vehicle is at normal idle RPM. Vehicles such as Toyota and Honda will run at a very high
idle for a number of minutes when first started. If tach learned when the vehicle is at
high Idle, then remote started when the vehicle is cold. The engine does not increase to
the RPM that is was learned at.
The Following steps can be used to learn tach at a more suitable idle:
1) Start the vehicle and leave running by the ignition key until the engine idles down.
2) Press and hold the brake pedal.
3) Press and release the Program Button (Located on the antenna) then press and hold.
4) The park lights will flash to confirm Quick Learn Tach*.
Note: The remote starter must be Tach Learned before the Quick Tach Learn feature
will operate.
TIP- “Manual Low Idle Learn”. While in the tach learning mode firmly apply the park
brake then hold the brake pedal. Place the transmission into reverse gear and
wait for the park lights to flash confirming Tach Learn.