Teac 35XX Remote Starter User Manual


 
Page 11
REMOTE VEHICLE STARTER INSTALLATION MANUAL
Auto Tach Learn
1) Turn the ignition key to the “ON” position. (The park lights will turn on*).
2) Start the vehicle with the key, The LEDs on the antenna will turn on if a proper tach
signal is detected**, then after 30-35 seconds the park lights will flash and the horn
(Optional) will honk twice to confirm Tach Learn.
* If the park lights do not turn on check for proper connection on the BLUE ignition
wire at the 6-pin connector. This wire should be connected to the vehicle main
ignition wire and must not turn off during the start position. If the ignition
connection is good reset the system and repeat step #1.
** If the LEDs do not come on during tach learn, a proper tach s ignal was not
detected.
If not tach learned the system will flash the park lights seven times when the start button
is pressed. The system must be Tach Learned before remote starting.
Note: If the park lights do not flash in auto tach learn mode it may be necessary to
connect to a different tach source. It is important the ignition output from the
remote starter is connected to a wire that does not turn off in the crank position.
The remote starter will not tach learn if connected to the wrong wire.
For best results connect the tach wire to the coil pack or to a fuel injector wire.
New - If the original Tach source is changed a system reset must be preformed
before a new tach signal can be learned to the system. This does not apply if the
Quick Learn feature is being used. See page 15 for system reset.
Your Basic Install Is Complete!
NOTES:
1) If the vehicle does not start when the remote starter is activated, check if the
park lights are flashing a diagnostic code. See diagnostic chart.
2) If the vehicle still does not start, check all connections and check for factory
Anti-Theft system.
Note: If the vehicle is not starting correctly it may be necessary to adjust the tach.
See Quick Tach Learn.