Filter
Top Products
2-108
BEFORE DRIVING
57L20-03E
Rain-sensing Wipers (if equipped)
57L21071
Press the engine switch to change the igni-
tion mode to “ON”. To turn the rain-sensing
wipers on, move the lever down to one of
the three operating positions. In the
“AUTO” position (if provided), the wipers
automatically operate when the wiper sys-
tem senses rain or snow. In the “LO” posi-
tion, the wipers operate at a steady low
speed. In the “HI” position, the wipers
operate at a steady high speed. To turn off
the wipers, move the lever back to the
“OFF” position.
Move the lever up and hold it to the “MIST”
position; the wipers will operate continu-
ously at low speed for as long as you hold
the lever in the “MIST” position.
57L21072
If the control lever has on “AUTO” position,
you can increase the system’s sensitivity to
rain/snow by turning the knob of the control
lever forward for increased sensitivity or
rearward for decreased sensitivity.
NOTE:
• Under the following conditions, the rain
sensor may not be able to sense rain or
snow correctly, and thus the rain-sensing
wiper function may not work or may work
incorrectly. (Use a position other than
“AUTO” under these conditions.)
– Rain or snow does not hit the rain sen-
sor area of the windshield, or the snow
is not of a type that is able to be
detected by the sensor.
– The rain sensor area is covered with
mud, ice or other similar substance.
You should remove any foreign sub-
stance.
MIST
OFF
AUTO
LO
HI
WARNING
• Observe the following instructions
when the wiper lever is set to the
“AUTO” position with the engine
switch in the “ON” mode. Other-
wise, the wipers could unexpect-
edly operate and cause injury, and
could also be damaged.
– Do not touch or wipe the rain
sensor area of the windshield
with a cloth.
– Do not hit the windshield or rain
sensor.
• Be sure to set the wiper control
lever to the “OFF” position before
washing the vehicle in an auto-
matic car wash or cleaning the
windshield.