Filter
Top Products
15
Initial Setup & Assembly
Install Lift Rod
NOTE: Two lift rods are packaged with the
Broadmoor/LT/1600/2600 & Landlord/GT/1700/2700
hitch assembly. Use the correct lift rod for manual or
hydraulic lift as shown in Figure 9.
1. Assemble lift rod per Figure 19.
2. Insert prong of rod guide (A, Figure 20) through hole
in upright of lift arm (B), and secure with spring clip
(C).
Hydraulic/Electric Lift Units:
3. If your tractor is equipped with hydraulic/electric lift,
install the lift lever extension assembly (A, Figure 21)
to the lift arm (B) as shown. Secure with clevis pin (C)
and spring clip (D) provided.
4. Install the 3/8 pin (E) removed from the mower and
secure with spring clip (D).
Manual Lift Lever Units:
3. Connect rear of lift rod (A, Figure 22) to manual lift
lever (B), and secure with spring clip (C).
Lift Rod Adjustment
Different types of terrain may require an adjustment to
the lift rod assembly. For instructions on how to make
this adjustment refer to the “Lift Rod Adjustment”
procedure in the ADJUSTMENTS section of this man-
ual.
Figure 20. Lift Rod Assembly
A. Rod Guide
B. Push Bar Lift Arm
C. Spring Clip
Figure 21. Hydraulic Lift Bracket
A. Lift Lever Ext. Assy D. Spring Clip
B. Lift Arm E. 3/8 Mower Pin
C. Clevis Pin
Viewed from Right Side of Tractor
Figure 22. Installing Lift Rod to Manual Lift Lever
A. Lift Rod C. Spring Clip
B. Manual Lift Lever
B
A
C
A
B
C
D
E
Figure 19. Lift Rod Assembly
A. Set Collars C. Spring
B. Rod Guide D. Lift Rod
A
B
A
B
C
C
D