Filter
Top Products
14
Initial Setup & Assembly
Install Spring Assist Bracket
(Baron/Broadmoor/1600/2600 Models Only)
NOTE: Spring-assist bracket assembly (Figure 16) does
not need to be installed on units with electric/hydraulic lift.
1. Install the spring-assist bracket (A, Figure 16) to trac-
tor frame (bracket is mounted underneath frame).
Secure with capscrew (from top), lockwasher, and
nut. Place clevis pin (B) through bracket and install
flat washer, chain (C), second flat washer, and safety
clip (D).
2. Raise the push bar and attach the lift assist spring (B,
FIgure 17) to the assist spring bracket (A).
3. Connect the other end of the assist spring to the 6-
link chain (C, FIgure 16).
Figure 17. Lift Assist Spring
A. Assist Spring Bracket B. Assist Spring
Figure 18. Dozer Blade Assembled and Installed
A. Push Bar D. Spring Clip
B. Pivot Frame
C. Pivot Pin
Install Dozer Blade
1. Insert the front of the push bar (A, Figure 18) into
pivot frame (B) on rear of blade. Then install pivot pin
(C) down thru front holes in blade and push bar.
Secure the pivot pin (C) with a spring clip (D).
B
A
B
C
D
D
Figure 16. Spring Assist Bracket Assembly
A. Bracket C. 6-Link Chain
B. Clevis Pin D. Safety Clip
A