Filter
Top Products
12
Initial Setup & Assembly
Install Rear Push Bar Support
NOTE: Manual Lift Models-If your tractor is not already
equipped with a Large Lift Lever kit, install it at this time.
Follow the instructions supplied with the kit.
1. Assemble the push bar support (A, Figure 12) and
hitch (F) using the hardware shown in Figure 12. Do
not tighten the 5/8-11 nuts (B & E).
Install Hitch
CONNECT TO FRONT OF TRACTOR
1. Increase front tire pressure to 20 psi (138 kPa) to
compensate for added weight of the hitch and blade.
Be sure both tires have equal pressure.
2. From the front of tractor, slide the rear push bar
assembly under the tractor so that the hitch bar is
positioned at the front of the unit.
3. Turn the wheels fully left and lift the front hitch bar (B,
Figure 13) up onto the tractor brackets (C). Make
sure it is fully seated into the tractor brackets. Install
the long hitch pin (D) through the bracket. Secure it
with the safety clip (A).
Figure 13. Installing Hitch to Front of Tractor
A Safety Clip C. Tractor Brackets
B. Hitch Bar D. Hitch Pin
Figure 12. Attaching Push Bar Support to Hitch
A. Push Bar Support D. Spacer
B. Rear 5/8-11 Hex Nut E. 5/8-11 Hex Nut
C. Washer F. Hitch
A
B
C
F
D
D
C
E
A
B