Scytek electronic 4000RS Automobile Alarm User Manual


 
ASTRA/G55 - Page 23
RPM Learn. Start the engine, enter Branch 21 and press Button 1 to learn the vehicle’s tach signal. The
siren will chirp and the LED will flash once to confirm learning of the tach signal and entering Tach
Monitor Mode. The siren will chirp four times and the LED will flash four times if the tach signal was not
learned, engine sense mode will not be changed.
Gas Engine.
Sets the engine type for Gasoline.
Diesel Engine.
Sets the engine type for Diesel and monitors the glow plug input to make sure the glow
plugs are warm before cranking the starter. If the glow plug wire is not connected, the built-in timer
waits 15 seconds before automatically cranking the starter.
22. Ignition 2 Relay Program. Selects one of three operating modes for the Ignition 2 relay output:
Ignition 2, Accessory 2, or Starter 2.
23. Auxiliary (-) Start Activation Pulse. (on the White wire of the 4-pin white connector, Shock
sensor port), Selects Between a one pulse, or three pulse operation for the external
negative start. (applys to ASTRA 1000RS only)
24. Siren Mode. Select between a regular siren and MP player siren.
25. Turbo Timer. When enabled, if the emergency brake (Blue wire of the shock sensor port) has been
applied Ignition power will be kept On for a predetermined time (2 minutes Factory Default) from the
application of the emergency brake. (applys to ASTRA 1000RS only)
26. Data Bus Input Trigger. When enabled, all available trigger from the Data Bus Module will be monitored.
( door,hood,brake and all other triggers will not be nessecery to hard wire).
27. Horn Chirp Duration. Selects between Normal,(default) Extended, and super extended horn On time
During chirping of the horn.
28. Factory Rearm Output Mode. Select between rearm or second ground when running on the pink wire
29. ASTRA System Mode: Selects between ASTRA 4000RS Series or ASTRA 1000RS Series.
Factory Defualt does not affect this setting.